Siemens SINUMERIK 840D Series Diagnostics Manual page 291

11.02
Remedy:
Program Continuation:
20102
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20103
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20105
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20106
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Check the connection to the digitizing unit (RS422 cable, supply voltage) and whether the
digitizing unit is switched on.
Clear alarm with the Delete key or NC START.
Channel %1: No or invalid trafo at digitizing active
%1 = Channel number
Prerequisite for the 3+2 axis digitizing is an active kinematic transformation. Permitted
transformations are the general 5-axis transformation and the universal inclinable head.
- Alarm display.
- Interface signals are set.
• Before digitizing, activate a permitted transformation.
• Select 3-axis mode for the digitizing via machine data.
Clear alarm with the Delete key or NC START.
Channel %1: digitizing module does not support 3+2 axis digitizing
%1 = Channel number
Prerequisite for 3+2 axis digitizing is that the NCU and the digitizing module both have the
3+2 axis mode.
- Alarm display.
- Interface signals are set.
• SW update for the digitizing module.
• Select 3-axis mode for the digitizing via machine data.
Clear alarm with the Delete key or NC START.
Channel %1: axes stopped by digitizer. Error code: %2
%1 = Channel number
%2 = Error code of digitizing unit
The digitizing unit has recognized an error in the communication and signaled this to the
NC.
- Alarm display.
- Interface signals are set.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
Please inform the authorized personnel/service department. Error code 1: Check cable
connection leading to the digitizing unit. Other error codes: See manual for digitizing unit.
Clear alarm with the RESET key. Restart part program
Emergency stop set by the digitizer
The digitizing unit has recognized a serious error and triggered an emergency stop.
Cause: See display on the digitizing unit.
- Alarm display.
- Interface signals are set.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
-
Clear alarm with the RESET key. Restart part program
1 Alarms
1-291