Siemens SINUMERIK 840D Series Diagnostics Manual page 157

11.02
Reactions:
Remedy:
Program Continuation:
14009
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14010
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14011
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Read out the part program, modify it with a text editor (e.g., insert blanks or comments
before the displayed block), so that after reading it in again the part program has a differ-
ent structure in the memory.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 illegal program path %3
%1 = Channel number
%2 = Block number, label
%3 = Program path
The part program command CALLPATH was called with a parameter (program path)
referring to a directory which does not exist in the file system of the NCK.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
• Modify the CALLPATH instruction such that the parameter contains the complete path
name of the loaded directory.
• Load the programmed directory in the file system of the NCK.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid default parameter in subroutine call
%1 = Channel number
%2 = Block number, label
In a subroutine call with parameter transfer, parameters have been omitted that cannot be
replaced by default parameters (call-by-reference parameters or parameters of type
AXIS. The other missing parameters are defaulted with the value 0 or with the unit frame
in the case of frames).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
The missing parameters must be provided with values in the subroutine call.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 program %3 not existing or will be edited
%1 = Channel number
%2 = Block number, label
%3 = Program name
An unknown identifier (string) was found in the part program. It is therefore assumed that
this is a program name. The part program indicated in a subprogram call or SETINT state-
ment does not exist or is not released for machining.
As of SW 5, when a program is edited on the MMC, it can no longer be started with NC
Start.
This alarm occurs if the PI FB-4 is being applied to a non-existent program.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
1 Alarms
1-157