Siemens SINUMERIK 840D Series Diagnostics Manual page 78

1 Alarms
8020
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8021
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8022
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8030
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8032
Parameters:
Definitions:
1-78
Option 'activation of more than %1 channels' not set
%1 = Number of channels
A 2nd channel has been indicated but the corresponding option does not exist.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
In the system-specific MD 10010 ASSIGN_CHAN_TO_MODE_GROUP, reduce the num-
ber of channels to 1 or retrofit the option for a 2nd channel.
Switch control OFF - ON.
Option 'activation of more than %1 mode groups' not set
%1 = Number of mode groups
The option for the number of mode groups is not compatible with the activated mode
group.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
Add option for more mode groups. Activate fewer mode groups.
Switch control OFF - ON.
Option 'activation of more than %1KB SRAM' not set
%1 = Memory size
The option for memory extension does not correspond to the active SRAM.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
Please inform the authorized personnel/service department.
• Buy option
• Activate less SRAM
Switch control OFF - ON.
Channel %1 block %2 option 'interpolation of more than 4 axes' not set
%1 = Channel number
%2 = Block number, label
The option for the number of interpolating axes does not correspond to the number of
axes programmed in the interpolation group.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Option: "Interpolation of more than 4 axes" (the number of axes that is then allowed can
be set in this option) or specify in the part program as many (or fewer, as required) axes
corresponding to the configuration of the control.
Clear alarm with the RESET key. Restart part program
Option 'activation of more than %1 link axes' not set
%1 = Number of axes
The option for the number of link axes does not match the number of axes programmed in
MD $MN_AXCONF_LOGIC_MACHAX_TAB.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02