Siemens SINUMERIK 840D Series Diagnostics Manual page 443

11.02
109006
Definitions:
Reactions:
Remedy:
Program Continuation:
109007
Definitions:
Reactions:
Remedy:
Program Continuation:
109008
Definitions:
Reactions:
Remedy:
Program Continuation:
111001
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111002
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111003
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
No switchover: Selected channel invalid
At this NCU, the MMC was switched to a channel that does not exist there.
- -
Set up the channel or adapt the parameterization of the NETNAMES.INI.
Internal
Channel switchover running
The channel switchover has been initiated.
A different MMC may have to be displaced.
- -
-
Internal
Activation is running
The switchover from the passive operating mode to the active operating mode has been
initiated.
- -
-
Internal
Non-interpretable step in line %1
%1 = Line number
The step is not an element of ManualTurn.
Easystep sequencer is not loaded.
- Alarm display.
Delete the program step or change the program in the operating area PROGRAMS in the
SINUMERIK 840D or 810D (CNC mode).
Internal
Insufficient memory, abort in line %1
%1 = Line number
Easystep sequencer has too many steps.
Easystep sequencer is not loaded.
- Alarm display.
Change the program in the operating area PROGRAMS in the SINUMERIK 840D or 810D
(CNC mode).
Internal
ManualTurn: %1
%1 = Error code
Internal system message over the ManualTurn operator panel.
- Alarm display.
Acknowledge error and inform Siemens.
Internal
1 Alarms
1-443