Siemens SINUMERIK 840D Series Diagnostics Manual page 263

11.02
17216
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17220
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17230
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17240
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 tool management: remove manual tool from spindle/toolholder %4 and
load manual tool %3, duplo no. %2
%1 = Channel number
%2 = Duplo no.
%3 = Tool identifier
%4 = Toolholder number (spindle number)
Indicates that the specified manual tool must be loaded in the specified toolholder or spin-
dle before the program is continued and that the manual tool located there must be
removed. A manual tool is a tool whose data are known to the NCK but which is not
assigned to a magazine location and is thus not fully accessible to the NCK, and usually
also to the machine, for an automatic tool change.
- Alarm display.
Make sure that the manual tools are exchanged. The alarm is cleared automatically after
PLC acknowledgement of the tool change on command. Manual tools can only be used
efficiently if this is supported by the PLC program.
Alarm display showing cause of alarm disappears. No further operator action
Channel %1 block %2 tool not existing
%1 = Channel number
%2 = Block number, label
If an attempt is made to access a tool via a T no. that has not (yet) been defined. For
example, when tools are to be put into magazine locations by programming $TC_MPP6 =
'toolNo'. This is possible only when both the magazine location and the tool given by
'toolNo' have been defined.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 Duplo no. already assigned
%1 = Channel number
%2 = Block number, label
If an attempt is made to write a tool Duplo number to the name of which another tool
(another T number) already exists with the same Duplo number.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal tool definition
%1 = Channel number
%2 = Block number, label
If an attempt is made to modify a tool data that would subsequently damage the data con-
sistency or lead to a conflicting definition, this alarm will appear.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
1 Alarms
1-263