Siemens SINUMERIK 840D Series Diagnostics Manual page 379

11.02
Reactions:
Remedy:
Program Continuation:
61013
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61101
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61102
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61103
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 basic settings were changed, program cannot be executed
%1 = Channel number
%2 = Block number, label channel number
The basic settings are not compatible with the generated program. Alarm triggered by fol-
lowing cycles: E_CP_CE, E_CP_CO, E_CP_DR, F_CP_CE, F_CP_CO, F_CP_DR.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check and, if necessary, change the basic settings.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 reference plane incorrectly defined
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE71, CYCLE72, CYCLE81 to CYCLE90,
CYCLE840, SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
With the relative specification of the depth, either different values for the reference plane
and the retraction plane must be selected or an absolute value must be specified for the
depth.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no spindle direction programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE86, CYCLE87, CYCLE88, CYCLE840,
POCKET3, POCKET4.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Parameter SDIR (or SDR in CYCLE840) must be programmed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 number of drillings is zero
%1 = Channel number
%2 = Block number, label
No value for the number of holes has been programmed. Alarm triggered by following
cycles: HOLES1, HOLES2.
1 Alarms
1-379