Siemens SINUMERIK 840D Series Diagnostics Manual page 382

1 Alarms
Reactions:
Remedy:
Program Continuation:
61112
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61113
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61114
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61115
Parameters:
Definitions:
1-382
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Infeed width must be reduced.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 tool radius negative
%1 = Channel number
%2 = Block number, label
The radius of the active tool is negative. This is illegal. Alarm triggered by following cycles:
CYCLE72, CYCLE76, CYCLE77, CYCLE90.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 parameter _CRAD for corner radius too large
%1 = Channel number
%2 = Block number, label
The parameter for the corner radius _CRAD has been specified too large. Alarm triggered
by following cycle: POCKET3.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Parameter must be reduced.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 machining direction G41/G42 incorrectly defined
%1 = Channel number
%2 = Block number, label
The machining direction of the cutter radius compensation G41/G42 has been incorrectly
selected. Alarm triggered by following cycle: CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Change machining direction.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 approach or retract mode (straight line/circle/plane/space)
incorrectly defined
%1 = Channel number
%2 = Block number, label
The approach or retract mode to/from the contour has been incorrectly defined. Alarm
triggered by following cycle: CYCLE72.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02