Siemens SINUMERIK 840D Series Diagnostics Manual page 435

11.02
Remedy:
Program Continuation:
104024
Definitions:
Reactions:
Remedy:
Program Continuation:
104025
Definitions:
Reactions:
Remedy:
Program Continuation:
104026
Definitions:
Reactions:
Remedy:
Program Continuation:
104027
Definitions:
Reactions:
Remedy:
Program Continuation:
104029
Definitions:
Reactions:
Remedy:
Program Continuation:
104030
Definitions:
Reactions:
Remedy:
Program Continuation:
105000
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Check loader.
Internal
Error during tool unloading
An error occurred while a tool was being unloaded; the procedure has been aborted.
- -
Check unloader.
Internal
No magazine configured
No magazine was configured.
- -
Configure a magazine via the machine data.
Internal
Notice: Tool is being loaded!
Note regarding loading process.
- -
Wait until the loading procedure is terminated.
Internal
Notice: Tool is being unloaded!
Note regarding unloading process.
- -
Wait until the unloading procedure is terminated.
Internal
Loading to this location not possible
The location may already be occupied.
- -
Select another loading location.
Internal
No more data available
All existing data was already displayed.
- -
-
Internal
Error x y
System-internal error.
A memory-access has failed - should not occur in normal operation.
- -
-
Internal
1 Alarms
1-435