Siemens SINUMERIK 840D Series Diagnostics Manual page 108

1 Alarms
10783
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10784
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10790
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-108
Channel %1 block %2 tool radius compensation type requires orientation transfor-
mation
%1 = Channel number
%2 = Block number, label
This alarm occurs, if an attempt is made to activate a tool radius compensation which
must enable a tool orientation change and the "Orientation transformation" option is not
available. This alarm can only occur if one of the following G code is active in the G code
group 22:
• CUT3DC
• CUT3DCC
• CUT3DCCD
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
• Modify part program
• Install "Orientation transformation" option
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal tool for tool radius compensation with constraint sur-
face
%1 = Channel number
%2 = Block number, label
When activating the tool radius compensation with constraint surface, an illegal tool type
is active.
Only cutting tools of the tool types 1 to 399 are admitted with the following exceptions:
• 111 ball end milling cutter
• 155 torus milling cutter
• 156 torus milling cutter
• 157 torus milling cutter
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Use another tool.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 plane change during linear programming with angles
%1 = Channel number
%2 = Block number, label
The active plane was changed between the first and second subblock when programming
two straight lines with angle parameters.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02