Siemens SINUMERIK 840D Series Diagnostics Manual page 467

11.02
300009
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300010
Parameters:
Definitions:
Reactions:
Remedy:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Axis %1 drive %2 measuring circuit %3 wrong measuring circuit type (type %4
used)
%1 = NC axis number
%2 = Drive number
%3 = Measuring circuit number
%4 = Measuring circuit type
The available, displayed actual value module on the drive FBG cannot process the signal
type that was stated via the axis-specific machine data 30240 ENC_TYPE [e]=S (e ...
encoder index - the position control works with this encoder, E ... , S ... signal type of the
actual value encoder - 0 ... simulation axis without hardware, 1 ... raw encoder signals, 2
... rectangle signals).
- NC not ready.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department.
Set MD 30240 ENC_TYPE [e] to 1 (0 should only be entered for pure simulation axes
which are to travel in the actual-value display only).
Switch control OFF - ON.
Axis %1 drive %2 active without NC axis assignment
%1 = NC axis number
%2 = Drive number
A drive is active that is not used/addressed by any NC axis (actual value, setpoint).
All active drives must be assigned to an axis with respect to the setpoint value or the
actual value.
- NC not ready.
- Channel not ready.
- NC Stop on alarm.
- NC Start disable in this channel.
- The NC switches to follow-up mode.
- Alarm display.
- Interface signals are set.
Please inform the authorized personnel/service department. Check the configuration
data, the assignment of setpoints and actual values for the drive motor and the position
encoder.
MDs for the drive configuration:
• Modify MD 13000: DRIVE_IS_ACTIVE
• Modify MD 13010: DRIVE_LOGIC_NR
• Modify MD 13020: DRIVE_INVERTER_CODE
• Modify MD 13030: DRIVE_MODULE_TYPE
• Modify MD 13040: DRIVE_TYPE
MDs for the setpoint/actual-value assignment:
• Modify MD 30110: CTRLOUT_MODULE_NR
• Modify MD 30130: CTRLOUT_TYPE
• Modify MD 30220: ENC_MODULE_NR
• Modify MD 30230: ENC_INPUT_NR
• Modify MD 30240: ENC_TYPE
1 Alarms
1-467