Siemens SINUMERIK 840D Series Diagnostics Manual page 406

1 Alarms
61808
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61809
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61810
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61811
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61812
Parameters:
Definitions:
1-406
Channel %1 block %2: The final drilling depth or individual drilling depth is missing
%1 = Channel number
%2 = Block number, label
The total depth Z or individual drilling depth Q is missing from theG8xblock (initial cycle
call).
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: Impermissible drilling position
%1 = Channel number
%2 = Block number, label
-
- -
-
Internal
Channel %1 block %2: ISO-G code not possible
%1 = Channel number
%2 = Block number, label
In the call block an impermissible ISO axis name was programmed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: Impermissible ISO axis name
%1 = Channel number
%2 = Block number, label
In the call block an impermissible numerical value was programmed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: Value(s) in the external cycle call incorrectly defined
%1 = Channel number
%2 = Block number, label
In the call block an impermissible numerical value was programmed.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02