Siemens SINUMERIK 840D Series Diagnostics Manual page 398

1 Alarms
61254
Definitions:
Reactions:
Remedy:
Program Continuation:
61255
Definitions:
Reactions:
Remedy:
Program Continuation:
61301
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61302
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61303
Parameters:
Definitions:
1-398
Channel %1 block %2: Error when traversing to fixed stop
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
specify another Z1 position for gripping the counterspindle.
Internal
Channel %1 block %2: Cut-off error: Tool breakage?
Cut-off could not be completely carried out.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check the tool.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 measuring probe does not switch
%1 = Channel number
%2 = Block number, label
The measuring distance was completely traversed but no switching signal was generated
at the measuring input specified by MD 9750or MD 9751.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
• Check measuring probe connection
• Set a longer measuring distance via MD 9752, 9753, 9754, 9755
• When measuring an edge: Position closer to the edge
• For spigots/holes: Position roughly over the middle
• Check value for spigot/hole diameter
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 measuring probe collision
%1 = Channel number
%2 = Block number, label
The measuring probe collided with an obstacle when being positioned.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
• Check spigot diameter (may be too small) check measuring distance (may be to long)
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 safe area exceeded
%1 = Channel number
%2 = Block number, label
Measuring result deviates greatly from specified value for the spigot/hole diameter.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02