Siemens SINUMERIK 840D Series Diagnostics Manual page 146

1 Alarms
Remedy:
Program Continuation:
12560
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12570
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12571
Parameters:
Definitions:
1-146
• Correct the name used (writing error)
• $TC_DPCx, $TC_TPCx, $TC_MOPCx, $TC_MAPCx, $TC_MPPCx, $TC_DPCSx,
$TC_TPCSx, $TC_MOPCSx, $TC_MAPCSx, $TC_MPPCSx; with x=1,...10
• These are the OEM parameters of the tools magazines, The corresponding machine
data value is set to < 10, or the option 'TM OEM parameters' has not been set.
• Use correct parameter number, or - if the name cannot be changed - set machine data
correction (see $MN_MM_NUM_CC_TOA_PARAM, ...
$MN_MM_NUM_CCS_TOA_PARAM, ...). )
• Check the option (machine data are only effective when the option is enabled).
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 programmed value %3 exceeds allowed limits
%1 = Channel number
%2 = Block number, label
%3 = Source string
In a value assignment, the permissible value range of the data type has been exceeded.
- Alarm display.
- Interface signals are set.
- Correction block
Press the NC Stop key and select the function "Correction block" with the soft key PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Assign value within the value range of the various data types, or if necessary use another
type in order to increase the size of the value range, e.g. INT ->REAL.
Value ranges of the various variable types:
• REAL: Property: Fractional number with dec. pt., value range: +/-(2-1022-2+1023)
• INT: Property: Integers with signs, value range: +/-(231-1)
• BOOL: Property: Truth value TRUE, FALSE, value range: 0,1
• CHAR: Property: 1 ASCII character, value range: 0-255
• STRING: Property: Character string (max. 100 values), value range: 0-255
• AXIS: Property: Axis addresses, value range: Axis names only
• FRAME: Property: Geometric information, value range: As for axis paths
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 too many motion synchronous actions in %3
%1 = Channel number
%2 = Block number, label
%3 = Source symbol
No more than 16 actions are allowed in a block with motion synchronous action.
- Alarm display.
- Interface signals are set.
- Correction block
Reduce the number of programmed actions.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 %3 not permissible for motion synchronous action
%1 = Channel number
%2 = Block number, label
%3 = Source symbol
The predefined subprogram %3 specified here is not allowed in a block with motion syn-
chronous action. It may only be contained in a "normal" block.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02