Siemens SINUMERIK 840D Series Diagnostics Manual page 205

11.02
Reactions:
Remedy:
Program Continuation:
14824
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14840
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
• An attempt has been made to select tool monitoring for a spindle that is already
assigned to another tool by TMON, GWPSON, CLGON or activation of tool length com-
pensation.
• An attempt has been made to select tool monitoring for the active tool although no tool
length compensation has been activated.
• Invalid parameter number for radius computation in $TC_TPG9.
The following values are valid:
3 for $TC_DP3 (length 1)
4 for $TC_DP4 (length 2)
5 for $TC_DP5 (length 3)
6 for $TC_DP6 (radius)
• A grinding wheel radius equal to zero was specified.
On deselecting tool monitoring with TMOF, one of the following errors occurred:
• Deselection does not refer to a grinding-specific tool (400-499).
• An attempt has been made to deselect tool monitoring for the active tool although tool
length compensation is not active.
• The deselection refers to an invalid spindle number.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Check TMON and TMOF command.
Check tool compensation data.
• $TC_DP1 : 400 - 499.
• $TC_TPG1: Spindle number.
• $TC_TPG8: Inclination angle for slope grinding wheel.
• $TC_TPG9: Parameter number for radius computation, e.g. 3 for $TC_GP3.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 conflict with GWPS
%1 = Channel number
%2 = Block number, label
The functions of constant grinding wheel surface speed GWPS and constant cutting
speed G96 S... have been activated at the same time for a spindle.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 incorrect value range for constant cutting speed
%1 = Channel number
%2 = Block number, label
The programmed cutting speed is not within the input range
Input range metric: 0.01 to 9 999.99 [m/min]
Input range inch: 0.1 to 99 999.99 [inch/min].
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Program cutting speed under address S within the permissible range of values.
Clear alarm with NC START or RESET key and continue the program.
1 Alarms
1-205