Siemens SINUMERIK 840D Series Diagnostics Manual page 421

11.02
101006
Definitions:
Reactions:
Remedy:
Program Continuation:
101007
Definitions:
Reactions:
Remedy:
Program Continuation:
101008
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
101013
Definitions:
Reactions:
Remedy:
Program Continuation:
101016
Definitions:
Reactions:
Remedy:
Program Continuation:
101017
Definitions:
Reactions:
Remedy:
Program Continuation:
101018
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Password is deleted!
The password was deleted via the soft key "Delete password".
- -
Enter password.
Internal
Password is not set!
To delete the password, a higher access authorization is required (at least user).
- -
Set the password with a higher access level.
Internal
Current access level: %1
%1 = Access-level system, manufacturer, service or user.
When selecting the alarm image, the current access level is displayed: system, manufac-
turer, service or user or keyswitch positions 3/2/1/0.
- -
-
Internal
Input error - see help - (i)-key
PLC status A syntax error occurred while entering a value in the PLC status.
The input syntax is explained in a help image.
- -
-
Internal
Error: The operand address is greater than 65535!
The value range of the operand address was exceeded.
- -
Use a smaller value range for the operand address.
Internal
No PLC input screen forms found!
There are no *.plc input screen forms in the target system.
- -
-
Internal
Reading-in only possible in an active PLC status!
The current PLC status mode is not active, e.g. if the soft key "Change" was pressed.
- -
Switch the PLC status to active.
Internal
1 Alarms
1-421