Photoreceptor Drum - Xerox 2510 Service Manual

REP 9.3 Photoreceptor Drum
4. (Figure 1): Remove photoreceptor drum 1. (Figure 2): Install photoreceptor drum shaft.
shaft.
1
Parts List on PL 9.1
NOTE: STEP 1A: Ensure that the top o f the drum
Replacement
box is up before opening the box.
Removal
CAUTION
WARNING
NOTE: STEP 1 D: The end shields (2) must be
Disconnect the power cord
Do not remove the light shield until Step 2
raised i n order t o position the drum shaft
when the photoreceptor is ready t o be
end plates against the drum fully.
Remove the separator guides, the right
installed i n the xerographic module,
side cover, and the left side cover.
NOTE: STEP
ID: When installing the drum shaft,
Remove the xerographic module (REP
9.1).
Remove photoreceptor drum assembly
(REP 9.3);
REMOVE SHAFT
Figure
1.
Remove Photoreceptor Drum Shaft
be sure l o lighten the three retaining
screws evenly and with equal pressure.
n
INSTALL
Y
INSTALL (3)
Figure 2. Install the Drum Shaft
(Continued)
7/92
REP 9.3
4-14 2510/2515