2510 Oil Pads - Xerox 2510 Service Manual

REP 10.4 2510
Oil Pads
4. (Figure 2): Remove oil
pads.
I
Parts List on 10.4
Removal
WARNING:
Disconnect the power cord.
CAUTION
Fuser roll may be hot.
CAUTION
Handle the Oil Dispenser Assembly with care to avoid
bending the stripper fingers.
1 . Lower the copy feed shelf.
2.
Lower the transport latching cover.
3. (Figure 1 ) : Remove oil dispenser assembly.
1.
REMOVE COVER
B
REMOVE THE
OIL DISPENSER
\
A
REMOVE NUTS ( 4 )
REMOVE SCREWS ( 4 )
Figure 1. Remove Oil Dispenser
Assembly
Figure 2. Remove Oil Pads
NOTE: Ensure that the Fuser Roll screw heads clear the
oil dispense assembly bracket.
NOTE: If an old oil wick is used spread some fuser oil
on the dirty ares and gently scrape it with a
piece of ,030 inch shim stock or feeler gauge
material and wipe the wick with a towel.
NOTE: When
a
new wick is installed, or if the old wick
is dry, prime it with fuser oil prior to use. To
prime the wick, rub the wick surface w i t h a new
oil pad prior to installing the pad in to the oil
dispenser assembly. This is necessary due t o
fact that i t takes approximately24 hours for the
oil to travel from the pads to the wick.
REP 10.4