Of 2 High Toner Consumption - Xerox 2510 Service Manual

OF 2 High Toner Consumption
Initial Actions
Check the following to ensure that a high toner
consumption problem exists.
The toner yield from one cartridge i s less
than 2000 linear feet.
The toner cartridge
i s
empty. Check that
the cartridge i s not damaged.
0
Toner in the Wnsle Toner Dollle i s above
the
Red Cap
in
the side
of
the bottle.
There
is
less than 10,000 linear feet
made since the last developer material
replacement.
Check the image area coverage and non-
image areas of the documents used by
the customer. Documents with a lot of
image or that have a dark non-image
area will use more toner.
There
i s a
high toner consumption problem.
Y
N
Inform the customer that the minimum
toner yield from one cartridge is less than
2000 linear feet.
Perform
the following:
8
Clenn the Plnten, Lens, nnd Transport
Platen.
@
Relor to the Taps Transfer procedura
(Section 6)
0
Perform the Image Density Adjustment
(ADJ 9.4).
0
Reduce the time interval of the Timeout
to Power Saver mode, Special Test
1.
Toner is dispensed during the cycle out
time.
If the problem persists, check the following:
DispenseSolenoid for binding and not
actuating correctly.
Dispense Solenoid
is
adjusted correctly
(ADJ
9.5).
Developer housing
Is
shorted to lhe
copier frame,
r
Developer Bias
is
switching correctly
(CQ
25)
High Voltage Power Supply is working
correctly
(
CQ 26)
2510 ONLY: Ensure that the Dispenser
Adjustment Handle and Dispenser Drive
Arm are not damaged and are operating
correctly.
If the problem is not corrected after trying all of
the above, call the Field Engineering hotline.
OF 2 High Toner
Consumtion
R A ~