Xerox 2510 Service Manual page 170

Corrective Action
10. Not enough developer material in the 10. Check the level of the developer material. The material
developer module. should be above the baffle in the rear of the module
and forming v-shaped piles against the rear of the
module. If not enough. replace the developer material
REP 9.9.
1 1. Damp media. 1 la. Cut sheet media
(Continued)
Make a copy using a sheet of media from the middle of
the stack of media in the Cut Sheet Feeder or the media
storage on the stand.
If the problem is corrected, check that the media heater
is working. Go t o one of the following:
1.
Damp Media RAP in Section 8B.
2. OF1 Media Clea,ter RAP in Section 2.
1 1 b. Roll media
Remove and discard the first 3 t o 6 feet (1 t o 2 metres)
of media from the roll.
Make
a copy on the new media.
If the problem i s corrected, ensure that the roll media i s
being stored correctly.
12.
Developer material has more than 30K feet 12. Replace the developer material (REP 9.8) and
(9K metres) of copies on it. perform the Electrostatic Series (ADJ 9.3).
13.
The copy is not fused.
13. Go t o the CQ 22 Unfused Copy RAP.
14. Airborne chemicals 14. Some chemicals can cause damage or contamination
of the drum.
Wash (General Procedures) or replace the drum (REP
9.3) and perform the Electrostatic Series (ADJ 9.3). If
the problem still exists, notify technical support.
6/93
CQ 11
The Light
Copy (Overall)
3-54 2510/2515