Exposure Lamp; Lens - Xerox 2510 Service Manual

REP 6.1 Exposure Lamp
Parts List
on PL 6.1
Replacement
NOTE: Ensure that the heatsink is i n place in
the center o f the exposure lamp and it
is not touching the rear document
drive rolls shaft.
I
NOTE: Ensure that the lamp part number is at
the right side o f the machine and the clear
slot is facing the illumination Sensor.
WARNING
(251 5 W/ Tags 2,7, or 89): There will be a
time delay between the time the code
[A]
is
entered and the time the motor starts to turn.
The motor will not start until the fuser i s at
the correct temperature.
Enter the diagnostic mode.
(2510,2515 W/O Tag 2,7, or 89):
Enter the code [L] and press Start.
Enter the code [g] and press Start.
Enter the code
[J]
and press Start.
Wait
2
minutes..
Enter the code
(A)
and press Start.
(2510,2515 W Tag 2.7, or 89):
Enter the code (A) and press Start.
Enter the code
IF]
and press Start.
Allow the copier t o run for
4
minutes to
prepare the new lamp for use.
Press Stop.
Perform the electrostatic series
(2510ADJ 9.2;
2515
ADJ
9.3).
REP6.2 ~ = n s
Parts List on PL 5.1
Removal
1. WARNING:
Disconnect power cord.
2. Remove the document handler.
3. Remove the platen.
4. Remove the exposure lamp.
5.
(Figure
1):
Remove the lens.
VlEW FROM THE REAR
Figure
1 .
Removing the Lens
Replacement
1. (Figure 2): Observe correct lens position.
NOTE: Step 1A: There are six slots i n the frame
into which the lens pins can be installed.
The slots in the lower position are for
the 251 Ol251S. The slots in the upper
position are for the 2520. Locating the
lens pins in the upper slots will cause an
out of focus condition i n the 2510 and
25 15.
I
INSTALL PINS INTO THE
LOWER SLOTS
(3
PLACES)
I
VlEW
FROM
THE REAR
Figure 2. The Correct Lens Position
LENS
REP 6.1, REP 6.2