Xerox 2510 Service Manual page 273

2. (Figure 3): lnsert the wick edge under the
3. (Figure 4): Install the plastic cover over the
plastic cover. oil pads.
NOTE: STEP 2 0:
If the plastic cover is l i f t e d
4. Install the oil dispense assembly.
too far, the narrow edge w i l l come o u t
from under the extrusion edge.
/
LIFT THE PLASTIC
COVER SLIGHTLY
FOLD THE WICK OVER THE OIL
PADS (FULL LENGTH) WHILE
DOING THE STEP B
Figure 3. Insert the wick Edge under the
Plastic Cover
OVE THE PLASTIC
PLASTIC COVER UNDER THE
EDGE OF THE EXTRUSION
(FULL LENGTH) WHILE DOING
L
'f/
THE STEP B
v
Figure 4. Install the Plastic Cover over the Oil Pads
7192
25101251 5 4-47
REP 10.8