Installation; Ground Polarity And Check - Xerox 2510 Service Manual

INSTALLATION
GROUND AND POLARITY CHECK
CAUTION
Before installing the copier, check for
correct voltage, polarity, and the
grounding of the AC outlet provided by
the customer. Use the Polarity Checker
(600T467) or a multimeter. Incorrect
voltage applied to the copier could result
in poor performance or damage to the
copier.
1. (Figure 1): Check the ground, voltage, and
polarity.
CAUTION
If specifications are not met, the AC
outlet is wired or grounded incorrectly.
Inform the Customer and request that a
licensed electrician correct the problem.
DO
NOTrnake the correction yourself.
2. (Figure 2): Check that the minimum
allowable space requirements are met.
...--
I
" (343
mm)
I
33" (880 mm)
I
Neutral
1 5 ~ m p
IACNI
60053704
Hot
iwhite
W H )
Wire) (Black
Wire)
Ground
NEMA =
(Green
5-1 5R
Preferred
Wire)
Figure 1. Checking the ground, voltage, and
polarity
a. Check for 107 t o 125 VAC between AC Hot
and AC Neutral.
b. Check for
107 t o 125 VAC between AC Hot
and ground.
c. Check for less than 2 VAC between A C
neutral and ground.
Figure
2.
Minimum Space Requirements
NOTE:
1.
2
3.
4.
5,
6.
Machines on Table Tops:
The table should be a minimum of 30
inches (762mm) high and a maximum
o f 36 inches (914mm) high.
The table must support a minimum
weight of 175 pounds (80
KG).
The top measurements should be a
maximum of 60 inches ( 1 524mm) wide,
and a maximum of 30 inches (762mm)
deep.
The space requirements are the same
as around the stand,
The table should be level within 114
inch (6.3mm) over36 inches (914mm).
If the copier is installed on a table, the
front edge of the copier should be
flush with the front edge of the
table. The copy feed shelf will extend
beyond the edge of the table.
NOTE: Fill out the quality report card
accurately and completely. Record all'
problems as they are encountered
doing the installation.
This product will produce ozone during
normal operation. The ozone produced
is dependent on copy volume and is
heavier than air. Providing the proper
environmental parameters as specified in
Xerox installation procedures will ensure
that concentration levels meet safe limits,
If additional information concerning
ozone is needed, request the Xerox
publication 600P83222, "OZONE
",
by
calling 1-800-828-6571,
8/96
251012515 6-1 3
Installation