Damaged Media Rap - Xerox 2510 Service Manual

Damaged Media RAP Probable Cause Corrective Action
1. Crease Marks 1.
A thin irregular line on the media
because of stressing the media.
2. Damaged Supply Roll
2.
There could be a flattened area at one
end of the roll.
3. Dog Ears 3.
A corner of the lead edge of the copy has
been bent back.
4. Frayed Side Edge 4.
This is damage to the sides of the copy.
5. Oil Streaks
5.
Streaks on the copy.
This defect can be caused by handling the 1.
media incorrectly.
Rolled media was not handled correctly and
2.
could have fallen on a hard surface during
handling of the roll.
Curled or roll cut media.
Detack corotron
Damaged media supply roll. 4.
Incorrect media side-to-side registration.
Obstruction in the media path.
Contamination or excessive amount of oil 5.
on the fuser oil pad and wick.
Ensure that the media is stored correctly
and is not folded or creased when inserted
in tho copier,
Replace the media roll.
Use the cut sheet media.
Check for an obstruction caused by the
detack corotron.
Replace the media roll.
Ensure that the media is inserted between
the guide marks on the media feed-in shelf.
Check the media path for an obstruction.
Clean or replace the oil pad (2510 REP 10.4,
2515
REP
10.5) and wick (2515
REP
10.5).
2510 adjust the oil dispense assembly (ADJ
10.2).
(Continued)
Damaged Media
RAP'