Xerox 2510 Service Manual page 262

Continued)
teplacement
JOT€: Before installing a new fuser roll, clean
the surface with film remover.
JOTE: Ensure that the thermistor is clean.
JOTE: When installing a new fuser roll, be
careful while installing the roll
through the side frame of the
xerographic module.
JOTE: Step
1
Cand D: When reinstalling the
(2) screws, ensure that the head of the
screw fits into the hole in the Fuser
Roll.
JOTE: Ensure that the thermistor touches the
heat roll.
,
(Figure 3): Reinstall the fuser roll.
!.
Reinstall the heat rod (REP 10.1).
I.
Perform the fuser roll initiation procedure
,
(Section 6, General Procedures).
Figure 3. Reinstall the Fuser Roll
REP 10.2