Xerox 2510 Service Manual page 353

NOTE: Inside the fuser roll, there is a packing
spring to support the fuser heat rod
during shipment.
12. (Figure 12): Prepare to remove the fuser
rod packing spring.
E
MANUALLY ROTATE THE FUSER
DRIVE GEAR UNTIL THE RETAINING
SCREWS ARE PARALLEL WITH THE
MEDIA PATH
MEDIA PATH
REMOVE FUSER
ROLL BEARING
SCREWS (2)
D
REMOVE THE
WIRE FROM CLIP
DISCONNECT (2)
0
cu'r
'I I IE CAIILE I IE
Figure 12. Preparing to Remove the fuser rod packing spring
7/92
25101251
5
6-1 7
Installation