Xerox 2510 Service Manual page 253

3. (Figure 4): Pre-tension springs.
4.
(Figure
5):
Tension springs.
Step A: The length of each spring body
NOTE: After moving the end blocks, check that the spring are
should be approximately 0.300 in.
(7.6mm) when not stretched.
NOTE: Step B: The spring then will be
stretched to 0.400 in. (10. Imm) by
pulling the corotron wire. Refore
stretching the sprlng, mark where the
spring will be stretched to achieve the
0.400 in. (10. Imm) length.
streched to 0.500 in
+
0.020
-
0.000 (1 2.7 mm
+
0.5mm
-
0.000 mm). If the 0.500 in (12.7 mm) dimension is not
correct, repeat Step 3 and increase the tension on the
springs if the dimension
is less than 0.500 in (12.7 mm)
and decrease the tension on the spring if the dimension
is greater than 0.500 Inch.
MARK
1Q.lmm)
Figure
4.
Pretension the Springs
CHECK
0,500"
( 1 7,5mm)
Figure
5.
Tension Springs
(Continued)
REP 9.10