Xerox 2510 Service Manual page 198

CQ 21 Streaks (TYPE 1.2, Dry ink
Streaks)
(Continued)
Probable Cause
3.
Developer housing
is
not functioning
3.
correctly or is not seated correctly.
4. Contaminated or damaged fuser
components.
Corrective Action
5. Contaminated media path components 5.
and baffles.
6. Contaminated media supply.
6.
7. Copier i s not level (side-to-side)
7.
Replace the developer material (REP 9.8)
and perform the Electrostatic Series
(2510
ADJ 9.2; 2515 ADJ 9.3) if it has made more
than
30K feet (9K metres) of coples. Check
the developer roll and material for
contamination. Replace as required.
Ensure that the developer housing is
seated correctly. Also ensure that the
material in the developer housing is level.
Check the fuser roll for contamination,
damage, or offsetting. If the fuser roll i s
damaged, check the stripper fingers
(2510
PL lO.4,2515 P L 10.5) for damage. If there
i s material from the fuser roll on the air
flow manifold, check the air flow manifold
(PL 9.3)
for interference to the fuser roll.
Check the
oil
dispense ossombly
for correct
operation. Check for contamination of the
fuser wick. Check the fabric guide for
damngo that may have caused the
contamination of the drum because of
excessive moisture.
Clean the contaminated media path
baffles and components.
Clean the media supply area.
Ensure that the copier i s level (side-to-
side).
(Continued)
7192
CQ 21 Streaks (Type 1.2, Dry Ink Streaks)
3-82