Xerox 2510 Service Manual page 254

5. (Figure 6): lnstall plastic wire retainers and NOTE:
dampers.
NOTE: When installing the dampers, ensure
that the edges of the dampers are
below lhe corotrm
dyes.
G. (I:lyuro 7): Insloll the corolron slrlng
shiold,
NOTE:
NOTE: Reinstall the string shield removed
at
the beginning of this procedure, or
install the plastic corotron shields.
Fold the string in half to determine the
center of the string. lnstall the center
o f the string over the cut-oc~t in the
center of the corotron. Wind one side
and sect~re before repealing llte s m e
procedure on tho other side,
Ensure that the corotron string shield
is tight enough that i l does not sag
and touch the corotron wire.
1 1 1 1
Figure
6.
lnstall Plastic Wire Retainers and Dampers
INSTALL CENTER OF
STRING ON CUT-OUT
Figure 7. Install Corotron String Shield
7/92
REP
9.10
4-30
251012515