Xerox 2510 Service Manual page 239

2. (Figure 3): Prepare
drum
lor installation,
CAUTION
Clean
the
auger to drum
seal (PL 9,1A,
Item 19) and move it towards the drum
to provide a seal between the
photoreceptor and the auger
extrusion. Replace the seal if it is
damaged. If the photoreceptor drum
is being replaced, replace the cleaner
blade also. Apply a light coating of
zinc stearate to the photoreceptor
drum and the cleaning blade.
1 \ p
F:$ovE (2) 1 EACH
VI
BLACK PLASTIC
LIGHT SHIELD
DUST THE
SURFACE OF
DRUM
WITH
S'l IiAIIA
I II
Figure
3.
Prepare Drum for Installation
3.
Install photoreceptor drum assembly in NOTE: STEP4 A:
Compress the
solenoid
xerographic module (REP 9.3).
plunger so that the cleaner blade
contacts with the photoreceptor
4. (Figure 4): Remove the stearate from the drum.
photoreceptor drum.
5 .
Install
xerographic module (REP 9.1).
6.
Perform the electrostatic series.
2510 ADJ 9.2 or 251 5 AD1 9.3
A
COMPRESS SOLENOID
PLUNGER
ROTATE UNTIL
PHOTORECEPTOR DRUM IS
CLEAR OF ALL STEARATE
1172
IR
J R S M 4
]MI
Figure 4. Remove the Stearate from the Photoreceptor Drum