Xerox 2510 Service Manual page 355

15. (Figure 15): Install the fuser bearing and
16. (Figure 15): Ensure that the fuser roll is not
the clip.
pinched under the mounting screws.
NOTE: The overheat thermostat must be in
17.
Lower and push in the cleaning blade
the up position towards the cleaning
weight, while ensuring that the opposite
blade solenoid weight. The overheat
end of the cleaning blade is seated.
thermostat connectors can be
interchanged with no effect on their
function.
tG-ki=?l
Figure
15.
Installing the Fuser Bearing
7/92
25101251s 6-1 9
Installation