Xerox 2510 Service Manual page 201

CQ 21 Streaks (TYPE 2.2,
Deleted Streaks)
(Continued)
Probable
Cause
4. Damaged media or damp media.
Corrective Action
4b. Roll media
Remove and discard the first
3
t o
6
feet
( 1
to
2
metres) of media from the roll. Make a copy on
the new media.
If the problem is corrected, ensure that the roll
media
is
being stored correctly.
5. Contaminants i n the developer material. 5. Inspect the developer material for foreign
material and replace the developer material (REP
9.8) if necessary. Perform the Electrostatic Series
(2510 ADJ 9.2; 2515 ADJ
9.3).
6. Developer housing is not seated correctly.
6. Ensure that the developer housing i s seated
correctly. Ensure that the developer housing is
operating correctly.
7.
Contaminated or damaged photoroceptor drum,
7.
W ~ s h (General Procedures) or replace tho
photoreceptor drum (REP 9.3) as required.
Perform the Electrostatic Series (2510 ADJ 9.2;
251 5 ADJ 9.3).
8. (25 10 ONLY): The developer seal
i s
damaged.
8. (2510 ONLY):
Replace the developer seal
CAUTION
Developer Module Repair Kit (PL 9.4).
Only the 2510 developer module can be repaired
using the developer module repair kit. The 2515
developer module is the same as the 2520
and
cannot be repaired, The manufacturing tolerances
are much tighter and cannot be set with out the
correct tools
9.
The auger t o drum seal is damaged. 9. Replace the auger t o drum seal (PL 9.1).
1 1 0. Damaged latch springs. 10. Replace the Latch Springs (PL 9.2).
8196
,
4
3-87
CQ 21 Streaks (Type 2.2, Deleted Streaks)