Xerox 2510 Service Manual page 293

21. Check the charge voltage.
a. Connect the red lead
(
+
)
to TPI
(Figure 7).
b. Press the
Start
button.
c. Observe that the DMM reads -0.250 to
-0.475 VDC.
I d. If voltage cannot be set to
specification, refer to the OF 5 Charge
Corotron Out of
Specification RAP.
22.
Prass Stop and switch off
tho
power.
2 1. Remove the electrometer.
23. Remove the document handler and the
two
(2)
sheets of20 pound (80 gsm) paper.
24. Install:
the developer module.
the document transport belt.
the document transport drive belt
the left side cover
the right side cover
the upper rear cover
the document handler
25. Continue with ADJ 9.4 Image Density on
next page.
251 01251 5 4-67
ADJ 9 . 3