Specifications - Xerox 2510 Service Manual

SPECIFICATIONS
PRODUCT CODES
The product code is located on the serial
number plate and identifies the product
configuration.
PHYSICAL CHARACTERISTICS
60 Hz 50 Hz
2510
Weight 175 Ib. 79.6 kg
Length 55 in. 1397 mm
Width 19 in. 483 mm
Height
13.5 in. 343 mm
251 5
Weight 180 1b. 81.8 kg
Length 55 in. 1397 mm
Width 19
in.
483 mm
Height 13.5 in. 343 mm
COPY RATE
Two inches per second (3 metres per
minute)
MAGNIFICATION
25IOl2515
I
1:1 nominal ( + 1%) with 20 Ib. (75 gsm)
bond and test pattern 82E5980.
ELECTRICAL POWER REQUIREMENTS
60 Hz:
The power outlet must be on
a
15-20
ampere line that is dedicated (wired directly t o
the circuit breaker panel with no shared
neutral and on a different phase from the
lighting circuit, in order t o prevent dimming
the lights).
60 Hz: 105-1 25 VAC, 60 Hz, single phase
50 Hz: 2201240 VAC, 50 Hz, single phase
Current at 1 15 VAC:
Standby (Power Saver): 4 amperes
Running: 12 amperes
Current at 230 VAC:
Standby (Low Power): 2 amperes
Running: 6 amperes
Power Consumption:
Standby (Power Saver1 Low Power): 460 watts
Running: 1380 watts (60 Hz); 1400 watts (50
Hz)
Power cord length: 10 Feet (3 Metres)
ENVIRONMENTAL DATA
Maximum Temperature:
Humidity:
Minimum Temperature:
Humidity:
Maximum Altitude: 7000 feet (2 132
metres) above sea
level
Heat Output (Average)
2510
Standby:
(powersaver
-
60 Hz): 1570 BTU I H R
Standby:
(Low Power
-
50 Hz): 109441 K- JOULESI H R
Running:
4700 BTU/ H R (297326.7 K-JOULES1 HR)
251 5
Stand by:
(Power Saver
-
60 Hz): 1730 BTU I H R
Standby:
(Low Power
-
50 Hz): 109441 K- JOULESI HR
Running:
5170 BTU/ H R (327059 K-JOULES/ HR)
Warmup Time:
80 seconds from room temperature.
Specifications
6-1 2 251012~15