Cleaner Blade Solenoid Purpose - Xerox 2510 Service Manual

ADJ 9.1 Cleaner
Blade Solenoid
Purpose
The purpose is to adjust the cleaning blade
solenoid so that the cleaner blade applies the
correct force to the drum.
NOTE:
(Figure 1) The drum must be i n the
xerographic module before performing
this check or adjustment. The nut
driver provides a 3
point stand to
avoids a twist in the assembly which
could result in an improper gap.
1. Remove the xerographic module (REP 9.1).
2. (Figure 1): Install the Nut Driver Handle
3.
Manually compress the plunger of the
solenoid.
Check
4.
(Figure 2): Check for
0.050
f
0.005
(1.2
mm
*0.1
mm) between the plunger and
the weight.
Adjustment
5. (Figure 2): Adjust the cleaning blade
solenoid.
Figure 1. Installing the Nut Driver Handle
6. Check the cleaning blade for correct
cleaning action.
a. Remove the Charge Corotron
b. Dust the drum with the dusting pouch.
c. Manually compress the solenoid
plunger while rotating the drum and
observe the cleaner action.
d. Reinstall the Charge Corotron
7. Rotate the Transition Gear to move the
weight to i t s closest position to the
xerograhic module frame. Check that there
is no interference between the weight and
frame.
Figure 2. Adjusting the Cleaner Blade Solenoid
6193
251012515 4-59
ADJ 9.1'