2515 Developer Module - Xerox 2510 Service Manual

REP 9.6 251 5 Developer Module
2.
I
Parts List on PL 9.5
Removal
NOTE: Before removing the developer 3.
module, ensure that there is a clear
area to place the assembly.
WARNING
Disconnect the power cord.
1. Remove the left and right side covers and
the upper rear cover.
Remove the toner cartridge. 4. (Figure 2): Remove the developer module.
CAUTION
Do not
lift the Revelopcr Morkllc by
NOTE: STEP4
a:
When loosening, ensure that
the auger tube,
the screw is loosened enough that the
(Figure 1): Hand position for removing the
developer module.
end of the screw is Inside the bracket
to avoid interference when removing
the developer module.
Figure 1. Hand Position for Removing the Developer Module
Y
LOOSEN
A
SCREWS (2)
ONE EACH
DISCONNECT END
Figure
4.
Removing the Developer
Module
(Continued)
7/92
251 5 4-21
REP 9.6