Xerox 2510 Service Manual page 247

CAUTION
2. (Figure 4): Install the developer module. 3. If the developer module installed in step 2
i s the one removed i n step
1 of this
Do not l i f t the developer module by the
removal, proceed to step 5. if a new
auger tube, refer to Figure I.
NOTE: STEP2 B: Ensure that the developer
developer module is being installed,
module i s fully installed in the brackets.
proceed to step 4.
NOTE: STEP 4 A: New develoaer modules are
I
Figure
4.
lnstall the Developer Module
shipped with the 'toner dispense
solenlod not Installed. l l w toner
dispense solenoid must
be
installed
before installing the toner cartridge.
If a new developer module has been
installed, perform the following:
A. lnstall the toner dispense solenoid
and ground clip (REP 9.8)
B. Perform the eleclrostatic series
(ADJ 9.3).
Install the toner cartridge.
Adjust the toner dispense solenoid
(ADJ 9.5).
7/92
251 5
4-23
REP 9:6