Suzuki WagonR+ RB310 Service Manual page 1483

8D-8 WINDOWS, MIRRORS, SECURITY AND LOCKS
3
5
4
4
1
1
3
5
6
2
7
2
2
Transmitter
REPLACEMENT OF TRANSMITTER BATTERY
If transmitter becomes unreliable, replace transmitter battery as
follows.
1) Remove screw (1), and remove cover (2) from ignition key
(3).
2) Unhook tabs (4) and remove transmitter (5).
3) Replace battery (lithium disc-type CR1616 or equivalent bat-
tery) (6) so its + terminal faces "+" mark (7) on transmitter
(5).
4) Set transmitter to cover (2).
5) Install cover (2) to ignition key (3) and tighten screw (1).
6) Make sure that keyless entry system can be operated with
transmitter.
CAUTION:
Use care not to allow grease or dirt to be attached on the
printed circuit board and the battery.
NOTE:
• To prevent theft, be sure to break the transmitter
before discarding it.
• Dispose of the used battery properly according to
applicable rules or regulations. Do not dispose of lith-
ium batteries with ordinary household trash.
CODE REGISTRATION PROCEDURE
If transmitter or door lock controller replace new one, register key
code as follows.
1) Confirm that all doors are closed and ignition key is out of
ignition key cylinder
2) Open driver side door.
3) Turn ignition switch to ON position, and then drawn ignition
key from ignition key cylinder within 10 seconds after that.
4) Push and release driver side door switch (1) at 3 times by
hand within 20 seconds after removing ignition key from igni-
tion key cylinder.
5) Turn ignition switch to ON position, and then drawn ignition
key from ignition key cylinder within 10 seconds after that.
6) Push "UNLOCK" button (2) on transmitter (3) and confirm
that all doors are operated from lock to unlock.
With this, code registration is completed.
NOTE:
• Three transmitter codes can be registered.
• When a new transmitter code is registered, the oldest
one will be cleared.