Chery T21 2014 Service Manual page 14

02 - INTRODUCTION
2. Remove parts
When repairing malfunction, try to determine the cause.
Before starting work, the parts or sub-assemblies that
have to be removed and replaced should be confirmed
first. After removing parts, block all holes and ports to
prevent foreign objects from entering.
02
3. Disassemble components
If disassembly procedures are complicated and multiple parts need to be disassembled, make sure that
disassembly methods won't affect the performance or appearance of parts. Identify each part for assembly.
4. Check parts
After removal, check each part for deformation, damage or other problems.
5. Arrange parts
Carefully arrange all the disassembled parts to make assembly easier.
Always separately arrange the replaced parts and reusable parts, and make marks on them.
6. Clean parts
Make a thorough and careful cleaning for reusable parts.
WARNING
 Blowing out the dirt or other particles with compressed air may hurt your eyes. Be sure to wear goggles
during operation.
7. Assemble components
When assembling parts, always strictly use the standard values (tightening torque and clearance value,
etc.).
If following parts need to be replaced, replace them with
new ones.
 Oil seal
 Gasket
 O-ring
 Lock washer
 Cotter pin
 Nylon nut
8
02–
Oil Seal
Gasket
O-ring
Chery Automobile Co., Ltd.
RT21020040
Cotter Pin
Nylon Nut
Lock Washer
RT21020050