Table of Contents
Advertisement
Integrator's Reference Manual for Polycom HDX Systems
prichannel
Sets or gets the PRI channels that will be active for the PRI line. This command is only applicable if you
have a PRI network interface connected to your system.
Syntax
prichannel get all
prichannel get {1..n}
prichannel set all
prichannel set {1..n} <on|off>
Parameter
get
all
{1..n}
set
on
off
Feedback Examples
● prichannel 1 set on
returns
prichannel 1 on
● prichannel set 23 off
returns
prichannel 23 off
● prichannel get 23
returns
prichannel 23 off
Important PRI Channel Information
Outgoing Call. For an outgoing call, the system uses the first active and available channel starting with the
lowest number from the channel range (1-23 for a PRI T1 and 1-30 for a PRI E1). If an additional channel
is needed, the system chooses the next incremental number. For example, if channels 1 through 7 are
inactive, but 8 is active and available, then 8 is the first channel that can be used by the system to place an
outgoing call. If an additional channel is needed, the system will use the next available active channel in the
range (which could be 9, and so on).
Incoming Calls. For incoming calls, the system may use the highest numbered channel in the range and,
if needed, proceed to the next channel number in descending order, depending on the type of third-party
Polycom, Inc.
Description
Returns the current setting. Requires a parameter from
<all|{1..n}>.
Selects all PRI channels and returns all channels and
settings similar to briallenable.
Range of available PRI channels. For PRI T1, the range
is 1..23. For PRI E1, the range is 1..30.
Sets the PRI channels to be active when followed by a
parameter from <all|{1..n}> and from <on|off>.
Activates the selected PRI channels.
Disables the selected PRI channels.
System Commands
381
Advertisement
Table of Contents
