Ntpserver - Polycom HDX 9006 Integrator's Manual

Integrator's Reference Manual for Polycom HDX Systems

ntpserver

Sets or gets an Network Time Protocol (NTP) server, using the IP address or the DNS name of the server.
Syntax
ntpserver get
ntpserver set ["xxx.xxx.xxx.xxx"|"server name"]
Parameter
get
set
"xxx.xxx.xxx.xxx"
"server name"
Feedback Examples
● ntpserver set
returns
ntpserver <empty>
● ntpserver set 192.168.1.205
returns
ntpserver 192.168.1.205
● ntpserver get
returns
ntpserver 192.168.1.205
Comments
This command allows you to use an internal time server and thus synchronize the system's time with the
time on your internal network. The system uses this time only for the local Call Detail Report.
See Also
See the ntpsecondaryserver
Polycom, Inc.
Description
Gets the IP address of the NTP server.
Sets the IP address of the NTP server when followed by
a valid parameter. To erase the current setting, omit the
["xxx.xxx.xxx.xxx"|"server name"] parameter.
The IP address of the NTP server.
The DNS name of the NTP server.
command on page 364.
System Commands
365