Table of Contents
Advertisement
Integrator's Reference Manual for Polycom HDX Systems
Comments
A restart of the system is required after successfully importing directory information and occurs
automatically after the import is complete.
When importing XML-formatted data, the imported data must be in the same format as was obtained from
the Polycom RealPresence Group system through the exportdirectory command or the export
directory utility in the web interface. When importing data back into the system, use the data in its entirety
(not edited in any form). The system may use the checksum utility to verify of integrity of the data when it is
imported back into the system.
Duplicate entries are overwritten; other entries in the imported directory are added into the system's local
directory.
All of the lines entered into the session after importdirectory is issued are interpreted as directory data.
You must include the importcomplete command as the last entry. Issuing the importcomplete
command on its own line indicates that the directory import is complete.
If no data is received for 60 seconds during import, the import ends, and an importdirectory timed
out error response is sent to the API session. All previous data entered is ignored.
Attempts to export and import directory information between different systems might fail. The message
import failed indicates that the system was not able to import the information.
Additional Usage Notes:
● Polycom HDX systems running software version 2.6 or later can import directory data exported from
systems running 2.6 and earlier versions.
● Polycom HDX systems running software versions earlier than 2.6 cannot import directory data
exported by systems running software version 2.6 or later.
See Also
See the
exportdirectory
Polycom, Inc.
command on page 235.
System Commands
301
Advertisement
Table of Contents
