Panasonic AFPX-C30R User Manual page 32

○
Tool port (RS232C)
6
This port is used to connect a programming tool.
A commercial mini-DIN 5-pin connector is used for the Tool port on the control unit.
The followings are the default settings set when the unit is shipped from the factory. The system register
"Tool port setting" should be used to change these.
Baud rate ........ 9600 bps
-
Character bit .... 8 bit
-
Parity check ..... Odd parity
-
Stop bit length .. 1 bit
-
Note) The unit numbers (station numbers) of the tool port should be specified using the system register
"Tool port setting".
○
Power supply and input terminal block
7
This is the power supply and input wiring terminal. A solderless terminal for M3 can be used.
○
Service power supply for input and output terminal block
8
This is the service power supply for input and output wiring terminal. A solderless terminal for M3 can be
used.
○
Expansion cover
9
It is used after the expansion cable and the battery has been installed.
○
Add-on cassette connector
10
○
Connector For connecting expansion I/O unit and expansion FP0 adapter
11
An exclusive expansion cable is inserted.
○
Battery cover
12
This battery cover is removed when the optional backup battery is installed.
Installing the backup battery enables the backup of the realtime clock or data registers.
○
DIN rail attachment lever
13
This lever enables the units to attach to a DIN rail at a touch.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Pin No. Signal name
1 Signal Ground
2 Send Data
3 Receive Data
4 (Not used)
5 +5V
Abbreviation Signal direction
SG
SD Unit → External device
RD Unit ← External device
−
+5V Unit → External device
−
−