Panasonic AFPX-C30R User Manual page 280

High-speed counter/pulse output control flag area of FP-X Tr type
High-speed counter control code monitor area
High-speed counter
Channel No.
ch0
ch1
ch2
ch3
ch4
ch5
ch6
ch7
ch8
ch9
chA
chB
Elapsed value write and read instruction (F1)
• This instruction changes or reads the elapsed value of the high-speed counter.
• Specify this instruction together with the special data register DT90300.
• The elapsed value is stored as 32-bit data in the combined area of special data registers DT90300 and
DT90301.
• Use this F1 (DMV) instruction to set the elapsed value.
Example 1: Writing the elapsed value
Example 2: Reading the elapsed value
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Control code monitor area
FP-X Ry type
DT90360
DT90361
DT90362
DT90363
DT90364
DT90365
DT90366
DT90367
DT90368
DT90369
DT90370
DT90371
Set the initial value of K3000 in the high-speed
counter.
Read the elapsed value of the high-speed
counter and copies it to DT100 and DT101.
• The area DT90052 for writing channels
and control codes is allocated as shown in
the left figure.
• Control codes written with an F0 (MV)
instruction are stored by channel in
special data registers DT90370 to
DT90377.
Note)
• In the reset input setting, the reset input
(X6 or X7) for CH0 or CH2 allocated in the
high-speed counter setting of the system
registers are defined to "enable/disable".
• The high-speed counter to be used with
the reset input is CH0 and CH2 only.
FP-X Tr type
DT90370
DT90371
DT90372
DT90373
DT90374
DT90375
DT90376
DT90377
-
-
-
-