Connecting A Surge Absorber - YASKAWA L1000A Technical Manual

8.5 Installing Peripheral Devices
■
Connecting a DC Link Choke
A DC link choke can be installed to drive models CIMR-LC2A0018 to 2A0075 and 4A0009 to 4A0039. When installing
a DC link choke, remove the jumper between terminals +1 and +2 (terminals are jumpered for shipment). The jumper
must be installed if not using a DC link choke. Refer to
Figure 8.11

◆ Connecting a Surge Absorber

A surge absorber suppresses surge voltage generated from switching an inductive load near the drive. Inductive loads
include magnetic contactors, relays, valves, solenoids, and brakes. Always use a surge absorber or diode when operating
with an inductive load.
WARNING! Fire Hazard. Due to surge absorber short circuit on drive output terminals U/T1, V/T2, and W/T3, do not connect surge
absorbers to the drive output power terminals. Failure to comply may result in serious injury or death by fire or flying debris.
◆ Connecting a Noise Filter
■
Input-Side Noise Filter
Drive outputs generate noise as a result of high-speed switching. This noise flows from inside the drive back to the power
supply, possibly affecting other equipment. Installing a noise filter to the input side of the drive can reduce the amount of
noise flowing back into the power supply. This also prevents noise from entering the drive from the power supply.
• Use a noise filter specifically designed for AC drives.
• Install the noise filter as close as possible to the drive.
Figure 8.12
322
A
A – Power supply
B – MCCB
Figure 8.11 Connecting a DC Link Choke
MCCB
A
MCCB
A – Power supply
B – Input-side noise
filter(model LNFD-
Figure 8.12 Input-Side Noise Filter (Three-Phase 200/400 V)
YASKAWA ELECTRIC SIEP C710616 38A YASKAWA AC Drive L1000A Technical Manual
Figure 8.11 for an example of DC link choke wiring.
C
B
R/L1
S/L2
T/L3
+ 1 + 2
D
C – Drive
D – DC Link Choke
B C
R/L1
R U
S/L2
S V
T/L3
T W
E
D
C – Drive
D – Other control device
)
Common_
TMonly
Y E A _
T M o n
ly