3.5
Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ Removing/Reattaching the Terminal Cover
■
Removing the Terminal Cover
Models CIMR- L 2A0018 to 2A0075 and 4A0009 to 4A0039
1.
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.
Figure 3.7
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal
cover.
Figure 3.8
Models CIMR- L 2A0085 to 2A0415 and 4A0045 to 4A0260
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
cover may fall off causing an injury.
Note: The shape of the terminal covers and the numbers of screws differ depending on the drive models.
on page 31
for details.
Figure 3.9
YASKAWA ELECTRIC SIEP C710616 38A YASKAWA AC Drive L1000A Technical Manual
Figure 3.3 Removing the Terminal Cover
Figure 3.4 Removing the Terminal Cover
Figure 3.5 Removing the Terminal Cover
YEA_common
YEA_common
Refer to Component Names
YEA_common
3.5 Terminal Cover
57
3