Understanding The Parameter Table - YASKAWA L1000A Technical Manual

B.1 Understanding the Parameter Table
B.1 Understanding the Parameter Table
◆ Control Modes, Symbols, and Terms
The table below lists terms and symbols used in this section to indicate which parameters are available in which control
modes.
Note: Refer to Control Mode Selection on page 28
Symbol
Parameter is available in all control modes.
All Modes
Parameter is available when operating the drive with V/f Control.
V/f
Parameter is available when operating the drive with Open Loop Vector.
OLV
Parameter is available when operating the drive with Closed Loop Vector.
CLV
Parameter is available when operating the drive with Closed Loop Vector for PM motors.
CLV/PM
Parameter can be changed during run.
Motor 2 Refers to a second motor when the drive is operating two motors. Switch between these motors using the multi-function input terminals.
Note: If a parameter is not available in a certain control mode, the symbol for that control mode is grayed out.
336
for detailed instructions on each control mode.
Table B.1 Symbols and Icons Used in the Parameter Table
YASKAWA ELECTRIC SIEP C710616 38A YASKAWA AC Drive L1000A Technical Manual
Description