Siemens SIMATIC FM 353 Manual page 76

Defining Parameters
Input of traversing programs
An empty window is provided for the input of NC traversing programs. Here you
can input your traversing program as follows:
Fig. 5-8
1. % Program number Program name
The "%" can be input only in the first line. This input is mandatory. The DB num-
ber is formed from the program number.
The program name is optional and may have up to 18 characters.
2. N<block number> − G<command> (G1, G2, G3) − X<value> − F<value> −
M<command> (M1, M2, M3) − D<No.> (tool offset number) − L<No.> −
P<No.> − (for NC programming see Chapter 10).
− You must enter the block number (N) first and in ascending order. The
rest of the inputs may be in any desired sequence.
− Input separators as a blank.
You must enter characters in upper case letters.
You can also use the input area at the top of the screen. The program number and
the program name are saved when you exit the input box. You can save the tra-
versing blocks with the "Save Block" button.
5-24
Entry for traversing programs
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0