Siemens SIMATIC FM 353 Manual page 179

8.1 Standard HMI (human-machine interface) for the OP 07
and the OP 17
Overview
This Section describes a preconfigured user interface, which you will need to
change according to your project (e. g. FM addresses, DB no.), for the following
COROS equipment (operator panels):
S OP 07
S OP 17
The tool to be used for this is the "ProTool/Lite" configuring tool. You can use it to
modify, add or delete graphics.
The user interface is addressed to user DB No.1 in the CPU (target system 1, ad-
dress = 2) and to the DB-SS of the FM 353 (target system 2, address = 3).
The text field "FM user name" represented in the images can be renamed to a text
of your choice.
You can print out the entire configuration using "ProTool/Lite". This provides you
with detailed graphics descriptions.
You will find the preconfigured user interfaces op07_353.pdb and op17_353.pdb
in the following directory:
[STEP7 directory]\EXAMPLES\FM353\zEn13_02_FM353_OP_EX
DB-SS
This data block for status messages (DB 1000) contains the control/checkback
signals, as well as the system data of the FM 353. The data of the DB-SS can only
be read.
Monitoring
The data for monitoring can be read and displayed directly in the DB-SS as well as
in the corresponding parameterized DBs of the FM 353.
The advantage of reading directly from the FM is that the values/signals do not
have to be read via the user program first.
Operator control
For operator control, the data and signals (including memory bits and values) are
written to the user DB of the user program.
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Human-machine Interface
8-3