Siemens SIMATIC FM 353 Manual page 331

Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
Machine data errors
5 (05) 102 (66) Limitation, software limit for linear axis
Cause
Effect
Elimination
Traversing program errors
8 (08) 1 (01) Program selection, subprogram number incorrect
Cause
Effect
Elimination
8 (08) 8 (08) Program selection, program number not in place
Cause
Effect
Elimination
8 (08) 9 (09) Program selection, block number not in place
Cause
Effect
Elimination
8 (08) 10 (0A) Program, block number unacceptable
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Error message,
error analysis and remedy
Error response: "Warning" see Table 11-2
For step resolutions < 1 MSR, the permissible traversing
range in the ratio of MSR to increments is limited (e.g. for 0.5
9
µm per step to 0.5@10 MSR) (see Section 5.3.1).
DB does not become effective and is stored non-retentively.
Correct and retransmit.
Error response: "Warning" see Table 11-2
S
The subroutine requested in the program is not in place
on the FM 353.
S
The subprogram called in the program contains another
subprogram call. Nesting is not possible.
Program selection is not executed
S
Parameterize and read in program, correct as necessary
S
Select another program
The program was not parameterized, not in place on the
FM 353.
Program selection is not executed
S
Parameterize and read in program, correct as necessary
S
Select another program
The block number is missing in the program selected
Program selection is not executed
S
Correct program
S
Select different block number
Block number missing or outside of the number range
Program is not stored
Correct program
Troubleshooting
Mes-
sage/
Display
CBS
or
DB
CBS
or
DB
CBS
or
DB
CBS
or
DB DB
CBS
or
DB DB
11-29