System Data - Siemens SIMATIC FM 353 Manual

9.3

System data

Overview
This chapter describes settings and functions that apply in multiple modes, and
that are likewise necessary in order to control and operate the FM 353, and data of
the FM available for checkback messages.
S Change parameters/data (Write request in user DB, DBX39.3), page 9-38
S Single functions (user DB, DBB34 and 35), page 9-42
S Single functions (user DB, DBB36 and 37), page 9-44
S Zero offset (Write request in the user DB, DBX39.1), page 9-46
S Set actual value (Write request in the user DB, DBX38.7), page 9-48
S Set actual value on-the-fly (Write request in the user DB, DBX39.0), page 9-49
S Request application data (Write request in the user DB, DBX39.6), page 9-50
S Teach in (Write request in the user DB, DBX39.7), page 9-51
S Set reference point (Write request in the user DB, DBX38.6), page 9-51
S Measured values, page 9-52
S Basic operating data (Read request in the user DB, DBX42.0), page 9-55
S Active NC block (Read request in the user DB, DBX42.1),
next NC block (Read request in the user DB, DBX42.2), page 9-56
S Application data (Read request in the user DB, DBX43.6), page 9-57
S Actual value block change (Read request in the user DB, DBX42.3), page 9-57
S Servicing data (Read request in the user DB, DBX42.4), page 9-57
S Additional operating data (Read request in the user DB, DBX43.5), page 9-58
S Parameters/data (Read request in the user DB, DBX43.3), page 9-58
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Description of Functions
9-37